Command Reference Guide

N8406-023 1Gb Intelligent L3 Switch Command Reference Guide (AOS) 120
IP Forwarding configuration
Command: /cfg/l3/frwd
[IP Forwarding Menu]
dirbr - Enable/disable forwarding directed broadcasts
on - Globally turn IP Forwarding ON
off - Globally turn IP Forwarding OFF
cur - Display current IP Forwarding configuration
The following table describes the IP Forwarding Configuration Menu options.
Table 128 IP Forwarding Configuration Menu options
Command
Description
dirbr disable|enable
Enables or disables forwarding directed broadcasts. This command is
disabled by default.
on
Enables IP forwarding (routing) on the switch.
off
Disables IP forwarding (routing) on the switch. Forwarding is turned off
by default.
cur
Displays the current IP forwarding settings.
Network Filter configuration
Command: /cfg/l3/nwf <1-256>
[IP Network Filter 1 Menu]
addr - IP Address
mask - IP Subnet mask
enable - Enable Network Filter
disable - Disable Network Filter
delete - Delete Network Filter
current - Display current Network Filter configuration
The following table describes the Network Filter Configuration Menu options.
Table 129 Network Filter Configuration Menu options
Command
Description
addr <IP address>
Sets the starting IP address for this filter. The default address is 0.0.0.0
mask <IP subnet mask>
Sets the IP subnet mask that is used with /cfg/l3/nwf/addr to
define the range of IP addresses that will be accepted by the peer when
the filter is enabled. The default value is 0.0.0.0
enable
Enables the Network Filter configuration.
disable
Disables the Network Filter configuration.
delete
Deletes the Network Filter configuration.
current
Displays the current the Network Filter configuration.
Route Map configuration
Command: /cfg/l3/rmap <1-32>
[IP Route Map 1 Menu]
alist - Access List number
metric - Set metric of the matched route
type - Set OSPF metric-type of the matched route
prec - Set the precedence of this route map
enable - Enable route map
disable - Disable route map
delete - Delete route map
current - Display current route map configuration
Routing maps control and modify routing information. The map number (1-32) represents the routing map you wish
to configure.