Command Reference Guide

N8406-023 1Gb Intelligent L3 Switch Command Reference Guide (AOS) 148
Table 175 RMON Alarm Menu options
Command
Description
almtype rising|falling|either
Configures the alarm type as rising, falling, or either (rising or falling).
The default is either.
rlimit < -2147483647 to
2147483647>
Configures the rising threshold for the sampled statistic. When the
current sampled value is greater than or equal to this threshold, and the
value at the last sampling interval was less than this threshold, a single
event is generated. The default value is 0.
flimit < -2147483647 to
2147483647>
Configures the falling threshold for the sampled statistic. When the
current sampled value is less than or equal to this threshold, and the
value at the last sampling interval was greater than this threshold, a
single event is generated. The default value is 0.
revtidx <0-65535>
Configures the rising alarm event index that is triggered when a rising
threshold is crossed.
The range is from 0 to 65535. The default value is 0.
fevtidx <0-65535>
Configures the falling alarm event index that is triggered when a falling
threshold is crossed.
The range is from 0 to 65535. The default value is 0.
owner <1-127 characters>
Enter a text string that identifies the person or entity that uses this alarm
index.
The owner can have a maximum of 127 characters.
delete
Deletes this alarm index.
cur
Displays the current RMON Alarm parameters.
Port mirroring
Command: /cfg/pmirr
[Port Mirroring Menu]
mirror - Enable/Disable Mirroring
monport - Monitoring Port based PM Menu
cur - Display All Mirrored and Monitoring Ports
The Port Mirroring Configuration Menu is used to configure, enable, and disable the monitored port. When enabled,
network packets being sent and/or received on a target port are duplicated and sent to a monitor port. By attaching
a network analyzer to the monitor port, you can collect detailed information about your network performance and
usage. Port mirroring is disabled by default.
NOTE: See the ―Troubleshooting tools‖ appendix in the N8406-023 1Gb Intelligent L3 Switch Application
Guide for information on how to use port mirroring.
The following table describes the Port Mirroring Configuration Menu options.
Table 176 Port Mirroring Configuration Menu options
Command
Description
mirror disable|enable
Enables or disables port mirroring. The default is disabled.
monport <port number>
Displays port mirroring menu.
cur
Displays current settings of the mirrored and monitoring ports.
Port-based port mirroring
Command: /cfg/pmirr/monport <port number>
[Port 1 Menu]
add - Add "Mirrored" port
rem - Rem "Mirrored" port
delete - Delete this ―Monitor‖ port
cur - Display current Port-based Port Mirroring configuration
The following table describes the port-based Port Mirroring Configuration Menu options.