Command Reference Guide

N8406-023 1Gb Intelligent L3 Switch Command Reference Guide (AOS) 153
Operations Menu
Introduction
Operations-level commands are used for making immediate and temporary changes to switch configuration. The
Operations Menu is used for bringing ports temporarily in and out of service. This menu is available only from an
administrator and operator login.
Menu information
Command: /oper
[Operations Menu]
port - Operational Port Menu
vrrp - Operational Virtual Router Redundancy Menu
passwd - Change current user password
clrlog - Clear syslog messages
ntpreq - Send NTP request
The following table describes the Operations Menu options.
Table 182 Operations Menu options
Command
Description
port <port number>
Displays the Operational Port Menu.
vrrp
Displays the Operational Virtual Router Redundancy Menu.
passwd <1-128
characters>
Allows the user to change the password. You need to enter the current password in
use for validation.
clrlog
Clears all Syslog messages. This command is available only from an administrator
login.
ntpreq
Allows the user to send requests to the NTP server. This command is available
only from an administrator login.
Operations-level port options
Command: /oper/port <port number>
[Operations Port 1 Menu]
8021x - 8021.x Menu
rmon - Enable/Disable RMON for port
ena - Enable port
dis - Disable port
cur - Current port state
Operations-level port options are used for temporarily disabling or enabling a port.
Table 183 Operations-Level Port Menu options
Command
Description
8021x
Displays the 802.1x Port Menu. This menu is available only from an administrator login.
rmon disable|enable
Enables or disables Remote Monitoring for the port. RMON must be enabled for any
RMON configurations to function.
ena
Temporarily enables the port. The port will be returned to its configured operation mode
when the switch is reset.
NOTE: This command does not enable a port that has been disabled by an ekeying mismatch error.
dis
Temporarily disables the port. The port will be returned to its configured operation mode
when the switch is reset.
cur
Displays the current settings for the port.