Command Reference Guide

N8406-023 1Gb Intelligent L3 Switch Command Reference Guide (AOS) 154
Operations-level port 802.1x options
Command: /oper/port <port number>/8021x
[802.1x Operation Menu]
reset - Reinitialize 802.1x access control on this port
reauth - Initiate reauthentication on this port now
Operations-level port 802.1x options are used to temporarily set 802.1x parameters for a port. This menu is
available only from an administrator login.
Table 184 Operations-Level Port 802.1x Menu options
Command
Description
reset
Re-initializes the 802.1x access-control parameters for the port. The following actions
take place, depending on the 802.1x port configuration:
force unauth - the port is placed in unauthorized state, and traffic is blocked.
auto - the port is placed in unauthorized state, then authentication is initiated.
force auth - the port is placed in authorized state, and authentication is not
required.
reauth
Re-authenticates the supplicant (client) attached to the port. This command only applies
if the port‘s 802.1x mode is configured as auto.
Operations-level VRRP options
Command: /oper/vrrp
[VRRP Operations Menu]
back - Set virtual router to backup
Operations-level VRRP options are described in the following table.
Table 185 Operations-Level VRRP Menu options
Command
Description
back <1-255>
Forces the specified master virtual router on this switch into backup mode. This is
generally used for passing master control back to a preferred switch once the preferred
switch has been returned to service after a failure. When this command is executed, the
current master gives up control and initiates a new election by temporarily advertising
its own priority level as 0 (lowest). After the new election, the virtual router forced into
backup mode by this command will resume master control in the following cases:
This switch owns the virtual router (the IP addresses of the virtual router and its IP
interface are the same)
This switch‘s virtual router has a higher priority and preemption is enabled.
There are no other virtual routers available to take master control.