Handbook

N8406-023 1Gb Intelligent L3 Switch Application Guide 126
e. Configure the OSPF Interface 2, and attach it to the stub area 1.
f. Click Submit.
6. Apply, verify, and save the configuration.
Example 2: Virtual links
In the example shown in the following figure, area 2 is not physically connected to the backbone as is usually
required. Instead, area 2 will be connected to the backbone via a virtual link through area 1. The virtual link must be
configured at each endpoint.
Figure 21 Configuring a virtual link
Configuring OSPF for a virtual link on Switch A
1. Configure IP interfaces on each network that will be attached to the switch.
1. Apply
3. Save
2. Verify
Switch
Switch
Blade Enclosure