Reference Guide

N8406-023 1Gb Intelligent L3 Switch Browser-based Interface Reference Guide 121
Table 92 Switch Image and Configuration Management controls
Control
Description
Configuration Filename
Selects the file name and location of the Configuration Block file to be
downloaded.
TS Dump Filename
Selects the filename for the TS (tech support) dump that you want to
upload to the TFTP server.
Flash Dump Filename
Selects the filename for the core (PANIC) dump that you want to upload
to the TFTP server.
Status of Previous Transfer
Displays the status of the previous software download attempt.
Switch Image and Configuration Management buttons
The following table describes Switch Image and Configuration Management buttons:
Table 93 Switch Image and Configuration Management buttons
Button
Description
Get Image
Starts download of the software image file indicated in TFTP Image Filename field
from the specified TFTP server.
Put Image
Starts upload of the software image file indicated in TFTP Image Filename field
from the specified TFTP server.
Get Config
Downloads a previously saved switch Configuration Block file indicated in
Configuration Filename from the specified the TFTP server.
The active configuration will be replaced with the commands found in the
downloaded configuration file. The file can contain a full switch configuration or a
partial switch configuration.
The new configuration is not activated until the apply command is used. If the apply
command is found in the configuration script file loaded using this command, the
apply action is performed automatically.
Put Config
Uploads the switch‘s active configuration to the script configuration file specified in
Configuration Filename. The file is placed on the TFTP server.
Put TS Dump
Uploads the TS (tech support) dump file to the TFTP server specified in TSTP TS
Dump Filename.
Put Dump
Uploads the core (PANIC) dump file to the TFTP server specified in Core Dump
Filename.
Clear Flash Dump
Deletes the core dump in flash memory.
Submit
When selected, the form is sent to the switch. Any configuration changes are
placed in the ―pending‖ state and do not take effect until the toolbar Apply
command is given.
REBOOT!
Reboots the switch.
NOTE: If the TFTP server is running SunOS or the Solaris operating system, the specified Put Config file
must exist prior to executing the Put Config command and must be writable (set with proper permission, and
not locked by any application). The contents of the specified file will be replaced with the current configuration
data.