Reference Guide

N8406-023 1Gb Intelligent L3 Switch Browser-based Interface Reference Guide 125
The following table describes the Switch Port Configuration controls:
Table 95 Switch Port Configuration controls
Control
Description
Switch Port State
Enables or disables the port.
RMON Instrumentation
Enables or disables Remote Monitoring for the port. The default is
disabled. RMON must be enabled for RMON statistics and history
sampling to function.
Media Setting
Configures the port‘s transmission media, as follows:
fiber
copper
auto
This field applies only to Ports 21-24.
VLAN Tagging
Disables or enables VLAN tagging for this port. It is disabled by
default.
PVID Tagging
Disables or enables VLAN tag persistence. When disabled, the VLAN
tag is removed from packets whose VLAN tag matches the port PVID.
The default value is enabled.
Port STP
Turns Spanning Tree On or Off for this port.
Default Port VLAN ID (1-4095)
Sets the default VLAN number which will be used to forward frames
which are not VLAN tagged.
The default number for all ports except Port 19 is 1.
Note: VLAN 4095 is reserved for switch management interface.
Flow Control
Sets the flow control. The choices include:
Receive flow control
Transmit flow control
Both receive and transmit flow control (default)
No flow control
Autonegotiation
Enables or disables auto negotiation for the port. The default is
enabled.
Speed
Sets the link speed. Not all options are valid on all ports. The choices
include:
10/100/1000, for automatic detection (default)
10 Mbps
100 Mbps
1000 Mbps
Note: Ports 1-18 are set to 1000Mb/s, and cannot be changed.
Duplex mode
Sets the operating mode. Not all options are valid on all ports. The
choices include:
Full/Half, for auto negotiation (default)
Full-duplex
Half-duplex
Note: Ports 1-16 are set to Full/Half and Ports 17-18 are set to Full-
duplex. These ports cannot be changed.
Enable/Disable sending Link UP/Down Trap
Enables or disables the sending of SNMP link up and link down traps.
The default setting is enabled.
Port Name
Sets a name for the port. The assigned port name appears next to the
port number on some information and statistics screens.
Multicast Threshold
Enables or disables multicast threshold limit.
Limits the number of multicast packets to the specified value. If
disabled (dis), the port forwards all multicast packets.
Multicast Threshold Rate (0-262143)
Configures the threshold rate for multicast packets, in packets per
second.
Broadcast Threshold
Enables or disables broadcast threshold limit.
Limits the number of broadcast packets to the specified value. If
disabled (dis), the port forwards all broadcast packets.
Broadcast Threshold Rate (0-262143)
Configures the threshold rate for broadcast packets, in packets per
second.
Destination Look Up Fail Threshold
Enables or disables threshold limit for destination lookup failures.
Limits the number of unknown unicast packets to the specified value. If
disabled (dis), the port forwards all unknown unicast packets.
Destination Lookup Fail Threshold Rate (0-
262143)
Configures the threshold rate for destination lookup failures, in packets
per second.
802.1p Port Priority (0-7)
Configures the port‘s 802.1p priority level.