Reference Guide

N8406-023 1Gb Intelligent L3 Switch Browser-based Interface Reference Guide 160
Network Filter Configuration
To display the following form, go to the Network Filters Configuration form. Select a network filter ID number, or
open the Network Filters folder and click Add Network Filter.
The following table describes the Network Filter Configuration controls:
Table 128 Network Filter Configuration controls
Control
Description
Network Filter Identifier (1-256)
Sets the numeric identifier for this network filter.
IP Address
Sets the starting IP address for this filter. The default address is 0.0.0.0
Enabled?
Enables or disables the Network Filter configuration.
Subnet Mask
Sets the IP subnet mask that is used to define the range of IP addresses that will
be accepted by the peer when the filter is enabled. The default value is 0.0.0.0