Reference Guide

N8406-023 1Gb Intelligent L3 Switch Browser-based Interface Reference Guide 178
The following table describes the OSPF Virtual Link Configuration controls:
Table 144 OSPF Virtual Link Configuration controls
Control
Descriptions
Virtual Link Identifier (1-3)
Assigns a numeric identifier to the virtual link.
Area Number (0-2)
Defines the area index used by the virtual link.
Enabled?
Enables or disables the OSPF virtual link. The default is disabled.
Hello Interval (1-65535 sec)
Displays the authentication parameters of a hello packet, which is set to be in an
interval of seconds. The default is 10 seconds.
Dead Interval (1-65535 sec)
Displays the health parameters of a hello packet, which is set to be in an interval of
seconds. Default is 60 seconds.
Transmit Delay (1-3600 sec)
Displays the delay in transit in seconds. Default is one second.
Retransmit Interval (1-3600 sec)
Displays the retransmit interval in seconds. Default is five seconds.
Virtual Neighbor Router ID
Displays the router ID of the virtual neighbor.
Authentication Key
Displays the password (up to eight characters) for each virtual link. Default is none.
MD5 Key ID (0-255)
Sets MD5 key ID for each virtual link. Default is 0 (none).
OSPF Hosts Configuration
To display the following form, select Layer 3 > OSPF Routing Protocol > OSPF Hosts (click the underlined text,
not the folder).