Reference Guide

N8406-023 1Gb Intelligent L3 Switch Browser-based Interface Reference Guide 181
RIP Interfaces Configuration
To display the following form, select Layer 3 > Routing Information Protocol > Routing Information Protocol >
RIP Interface (click the underlined text, not the folder).
RIP is used for configuring Routing Information Protocol parameters. This option is turned off by default.
NOTE: Do not configure RIP version 1 parameters if your routing equipment uses RIP version 2.
The following table describes the RIP Interfaces Configuration controls:
Table 148 RIP Interfaces Configuration controls
Control
Description
Search Range
To search for a RIP interface, enter a range of interface numbers in the From and To fields.
Search Options
To focus the search for a VLAN, enter optional search parameters:
RIP Version
RIP state
Fields that have a value of ―any‖ are ignored during the search.
Choose a search operation:
or: Search for RIP interfaces specified in the search range that meet any of the criteria
entered.
and: Search for RIP interfaces specified in the search range that meet all of the criteria
entered.
Click Search to display RIP interfaces that fit the range and meet the criteria entered.