Reference Guide

N8406-023 1Gb Intelligent L3 Switch Browser-based Interface Reference Guide 191
Bootstrap Protocol Relay Configuration
To display the following form, select Layer 3 > Bootstrap Protocol Relay.
The following table describes the Bootstrap Protocol Relay configuration controls:
Table 158 Bootstrap Protocol Relay Configuration controls
Control
Description
BOOTP Server IP Address
Sets the IP address of the BOOTP server.
Secondary BOOTP Server IP
Address
Sets the IP address of the secondary BOOTP server.
BOOTP State
Enables or disables the use of BOOTP. If you enable BOOTP, the switch will query its
BOOTP server for all of the switch IP parameters. The default value is disable.
IP Routing General Configuration
To display the following form, select Layer 3 > General.
The following table describes the IP Routing General Configuration controls:
Table 159 IP Routing General Configuration controls
Control
Description
IP Forwarding Enabled?
Enables or disables IP Forwarding. The default is disabled.
Enable Forwarding Directed
Broadcasts?
Enables or disables forwarding directed broadcasts.
IP Destination Re-ARP
Interval (2-120 minutes)
Sets the re-ARP period in minutes. The switch periodically sends ARP (Address
Resolution Protocol) requests to refresh its address database. This command is used for
setting the interval between ARP refreshes of the next IP address in the database. The
range is from 2 to 120 minutes. The default interval is 10 minutes.
Router ID
Configures the router ID.