Reference Guide

N8406-023 1Gb Intelligent L3 Switch Browser-based Interface Reference Guide 203
The following table describes the Failure Detection Pair Configuration controls:
Table 169 Failure Detection Pair Configuration controls
Control
Description
FDP Identifier (1-4)
Specifies the number of the Failover Pair.
Enable/Disable FDP
Enables or disables the Failover Pair. The default is disabled.
LtM Ports Available
Lists the ports that can be added to the Link to Monitor (LtM). Only uplink ports (20-24)
are allowed in the LtM.
LtM Ports Selected
Lists the ports that are members of the LtM.
Select a port number in the LtM Ports Available list and click Add to add the port to the
LtM.
Select a port number in the LtM Ports Selected list and click Remove to remove the port
from the LtM.
LtD Ports Available
Lists the ports that can be added to the Link to Disable (LtD). Only downlink ports (1-16)
are allowed in the LtD.
LtD Ports Selected
Lists the ports that are members of the LtD.
Select a port number in the LtD Ports Available list and click Add to add the port to the
LtD.
Select a port number in the LtD Ports Selected list and click Remove to remove the port
from the LtD.
LtM Trunks Available
Lists the trunk groups that can be added to the Link to Monitor (LtM). The LtM trunk
group can contain only uplink ports (20-24).
LtM Trunks Selected
Lists the trunk groups that are members of the LtM.
Select a trunk group number in the LtM Trunks Available list and click Add to add the
trunk group to the LtM.
Select a trunk group number in the LtM Trunks Selected list and click Remove to
remove the trunk group from the LtM.
LtD Trunks Available
Lists the trunk groups that can be added to the Link to Disable (LtD). LtD trunk groups
can contain only downlink ports (1-16).
LtD Trunks Selected
Lists the trunk groups that are members of the LtD.
Select a trunk group number in the LtD Trunks Available list and click Add to add the
trunk group to the LtD.
Select a trunk group number in the LtD Trunks Selected list and click Remove to
remove the trunk group from the LtD.
LtM Admin Keys Available
Lists the LACP trunk groups that can be added to the Link to Monitor (LtM). The LtM
LACP trunk group can contain only uplink ports (20-24).
LtM Admin Keys Selected
Lists the LACP trunk groups that are members of the LtM.
Select a LACP trunk group number in the LtM Admin Keys Available list and click Add
to add the LACP trunk group to the LtM.
Select a LACP trunk group number in the LtM Admin Keys Selected list and click
Remove to remove the LACP trunk group from the LtM.