Reference Guide

N8406-023 1Gb Intelligent L3 Switch Browser-based Interface Reference Guide 51
Table 39 RIP Interfaces Dashboard controls
Control
Description
Split Horizon
Displays whether Split Horizon is enabled or disabled.
Virtual Router Group Operation
To display the following form, select Layer 3 > VRRP > General.
The following table describes the VRRP General controls:
Table 40 Virtual Router Group Operation controls
Control
Description
Set Virtual Router Group to Backup
Forces the master virtual router group into backup mode. This is generally
used for passing master control back to a preferred switch once the
preferred switch has been returned to service after a failure. When this
command is executed, the current master gives up control and initiates a
new election by temporarily advertising its own priority level as 0 (lowest).
After the new election, the virtual router forced into backup mode by this
command will resume master control in the following cases:
This switch owns the virtual router (the IP addresses of the virtual router
and its IP interface are the same)
This switch‘s virtual router has a higher priority and preemption is
enabled.
There are no other virtual routers available to take master control.