User Guide

(English)
33
3
11
2
1
5
7
8
N8406-023
R ST
21 22 23 24
20
21 22 23 24
9
10 6
4
Description
Name
Description
1. ID LED
Identifies the Switch Module in the Blade Enclosure. The LED is lit by a software
command.
2. STATUS LED
Indicates the Switch Module status.
Contact your service representative if it does not turn green at least five minutes after
the Blade Enclosure is powered on.
3. Ejector
Use this lever to install or remove the Switch Module in/from the Blade Enclosure.
4. Serial Port
DB-9 management serial port.
5. Uplink port (RJ-45)
RJ-45 connectors for Gigabit Ethernet uplink
6. Uplink port
(SFP module slot)
SFP module connectors for optional fiber uplink
7. LINK/ACT LED
Indicates the link status and activity of each LAN port.
Off
Link not established
On (Green)
Link established
Flash (Green)
Data being transmitted or received
8. SPEED LED
Indicates the link speed.
Off
10Mbps
On (Green)
100Mbps
On (Amber)
1000Mbps
9. LINK LED
Indicates the link status of each LAN port.
Off
Link not established
On (Green)
Link established
10. ACT LED
Indicates the activity of each LAN port.
Flash (Green)
Data being transmitted or received
11. RESET Switch
Press this switch to restart the Switch Module.
Pressing the RESET switch reboots the Switch Module, clears the configuration
data not saved in the flash memory, and temporarily disconnects
communication with the network.
NOTE: The Switch Module is powered by the Blade Enclosure. It does not
have a POWER switch.