Command Reference Guide

Error! Use the Home tab to apply 見出し 1 to the text that you want to appear here. 100
The following table describes the System Access Configuration menu options.
Table 95 System Access Configuration Menu options
Command
Description
mgmt
Displays the Management Configuration Menu.
user
Displays the User Access Control Menu.
http
disable|enable
Enables or disables HTTP (Web) access to the Browser-based Interface. It is
enabled by default.
https
Displays the HTTPS Menu.
wport <TCP port
number>
Sets the switch port used for serving switch Web content. The default is HTTP port
80.
snmp disable|read-
only|read-write
Disables or provides read-only/write-read SNMP access.
tsbbi
enable|disable
Enables or disables BBI configuration controls for Telnet and SSH. It is disabled by
default.
tnet
disable|enable
Enables or disables telnet server. The default is enabled.
tnport <TCP port
number>
Sets an optional telnet server port number for cases where the server listens for
telnet sessions on a non-standard port.The default is telnet port 23.
tport <TFTP port
number>
Sets an optional TFTP server port number for cases where the server listens for TFTP
sessions on a non-standard port. The default is TFTP port 69.
cur
Displays the current system access parameters.
Management Networks configuration
Command: /cfg/sys/access/mgmt
[Management Networks Menu]
add - Add mgmt network definition
rem - Remove mgmt network definition
cur - Display current mgmt network definitions
clear - Clear current mgmt network definitions
The following table describes the Management Networks Configuration menu options. You can configure
up to 10 management networks on the switch.
Table 96 Management Networks Configuration menu options
Command
Description
add <IP address> <IP mask>
Adds a defined network through which switch access is
allowed through Telnet, SNMP, or the browser-based
interface. A range of IP addresses is produced when used
with a network mask address. Specify an IP address and
mask address in dotted-decimal notation.
rem <IP address> <IP mask>
Removes a defined network, which consists of a
management network address and a management
network mask address.
cur
Displays the current management networks parameters.
clear
Clears the management network definitions.