Command Reference Guide

Error! Use the Home tab to apply 見出し 1 to the text that you want to appear here. 107
Table 105 802.1x Global Configuration Menu options
Command
Description
suptmout <1-65535>
Sets the time, in seconds, the authenticator waits for an EAP-Response
packet from the supplicant (client) before retransmitting the EAP-
Request packet to the authentication server. The default value is 30
seconds.
svrtmout <1-65535>
Sets the time, in seconds, the authenticator waits for a response from
the Radius server before declaring an authentication timeout. The
default value is 30 seconds.
The time interval between transmissions of the RADIUS Access-Request
packet containing the supplicant‘s (client‘s) EAP-Response packet is
determined by the current setting of /cfg/sys/radius/timeout
(default is 3 seconds).
maxreq <1-10>
Sets the maximum number of times the authenticator retransmits an
EAP-Request packet to the supplicant (client). The default value is 2.
raperiod <1-604800>
Sets the time, in seconds, the authenticator waits before re-
authenticating a supplicant (client) when periodic re-authentication is
enabled. The default value is 3600 seconds.
reauth on|off
Sets the re-authentication status to on or off. The default value is off.
default
Resets the global 802.1x parameters to their default values.
cur
Displays current global 802.1x parameters.
802.1x Port configuration
Command: /cfg/l2/8021x/port <port number>
[802.1x Port Configuration Menu]
mode - Set access control mode
qtperiod - Set EAP-Request/Identity quiet time interval
txperiod - Set EAP-Request/Identity retransmission timeout
suptmout - Set EAP-Request retransmission timeout
svrtmout - Set server authentication request timeout
maxreq - Set max number of EAP-Request retransmissions
raperiod - Set reauthentication time interval
reauth - Set reauthentication status to on or off
default - Restore default 802.1x configuration
global - Apply current global 802.1x configuration to this port
cur - Display current 802.1x configuration
The 802.1x port menu allows you to configure parameters that affect the selected port in the switch.
These settings override the global 802.1x parameters.