Command Reference Guide

Error! Use the Home tab to apply 見出し 1 to the text that you want to appear here. 108
The following table describes the 802.1x Port Configuration Menu options.
Table 106 802.1x Port Configuration Menu options
Command
Description
mode force-
unauth|auto|force-auth
Sets the type of access control for the port:
force-unauth - the port is unauthorized unconditionally.
auto - the port is unauthorized until it is successfully authorized by
the RADIUS server.
force-auth - the port is authorized unconditionally, allowing all
traffic.
The default value is force-auth.
qtperiod <0-65535>
Sets the time, in seconds, the authenticator waits before transmitting
an EAP-Request/ Identity frame to the supplicant (client) after an
authentication failure in the previous round of authentication. The
default value is 60 seconds.
txperiod <1-65535>
Sets the time, in seconds, the authenticator waits for an EAP-
Response/Identity frame from the supplicant (client) before
retransmitting an EAP-Request/Identity frame. The default value is 30
seconds.
suptmout <1-65535>
Sets the time, in seconds, the authenticator waits for an EAP-Response
packet from the supplicant (client) before retransmitting the EAP-
Request packet to the authentication server. The default value is 30
seconds.
svrtmout <1-65535>
Sets the time, in seconds, the authenticator waits for a response from
the RADIUS server before declaring an authentication timeout. The
default value is 30 seconds.
The time interval between transmissions of the RADIUS Access-Request
packet containing the supplicant‘s (client‘s) EAP-Response packet is
determined by the current setting of /cfg/sys/radius/timeout
(default is 3 seconds).
maxreq <1-10>
Sets the maximum number of times the authenticator retransmits an
EAP-Request packet to the supplicant (client). The default value is 2.
raperiod <1-604800>
Sets the time, in seconds, the authenticator waits before re-
authenticating a supplicant (client) when periodic re-authentication is
enabled. The default value is 3600 seconds.
reauth on|off
Sets the re-authentication status to on or off. The default value is off.
default
Resets the port 802.1x parameters to their default values.
global
Applies the global 802.1x parameters to this port.
cur
Displays current port 802.1x parameters.