Command Reference Guide

Error! Use the Home tab to apply 見出し 1 to the text that you want to appear here. 120
Table 122 L3 Configuration Menu options
Command
Description
rtrid <IP address>
Configures the Router ID.
cur
Displays the current IP configuration.
IP interface configuration
Command: /cfg/l3/if <1-250>
[IP Interface 1 Menu]
addr - Set IP address
mask - Set subnet mask
vlan - Set VLAN number
relay - Enable/disable BOOTP relay
ena - Enable IP interface
dis - Disable IP interface
del - Delete IP interface
cur - Display current interface configuration
The switch can be configured with up to 250 IP interfaces. Each IP interface represents the switch on an IP
subnet on your network. The IP Interface option is disabled by default. Interface 256 is reserved for switch
management.
The following table describes the IP Interface Configuration Menu options.
Table 123 IP Interface Configuration Menu options
Command
Description
addr <IP address>
Configures the IP address of the switch interface, using dotted decimal
notation. For example, 192.2.14.101
mask <IP subnet mask>
Configures the IP subnet address mask for the interface using dotted
decimal notation. For example, 255.255.255.0
vlan <1-4094>
Configures the VLAN number for this interface. Each interface can
belong to one VLAN, though any VLAN can have multiple IP interfaces in
it.
relay
Enables or disables BOOTP relay on this IP interface. The default is
enabled.
ena
Enables this IP interface.
dis
Disables this IP interface.
del
Removes this IP interface.
cur
Displays the current interface settings.
NOTE: If you enter an IP address for interface 1, you are prompted to change the BOOTP setting.
Interface 250 is reserved for switch management interface.
Default Gateway configuration
Command: /cfg/l3/gw <1-4, 254>
[Default gateway 1 Menu]
addr - Set IP address
intr - Set interval between ping attempts
retry - Set number of failed attempts to declare gateway DOWN
arp - Enable/disable ARP only health checks
ena - Enable default gateway
dis - Disable default gateway
del - Delete default gateway
cur - Display current default gateway configuration
The switch supports up to four gateways, plus the management gateway 254. By default,
no gateways are configured on the switch. Enter 1, 2, 3, 4, or 254 in the command as the <gateway
number>, depending upon which gateway you want to configure.