Command Reference Guide

Error! Use the Home tab to apply 見出し 1 to the text that you want to appear here. 13
Menu basics
Introduction
The AOS CLI is used for viewing switch information and statistics. In addition, the administrator can use the
CLI for performing all levels of switch configuration.
To make the CLI easy to use, the various commands have been logically grouped into a series of menus
and submenus. Each menu displays a list of commands and/or submenus that are available, along with a
summary of what each command will do. Below each menu is a prompt where you can enter any
command appropriate to the current menu.
This chapter describes the Main Menu commands, and provides a list of commands and shortcuts that
are commonly available from all the menus within the CLI.
Main Menu
The Main Menu displays after a successful connection and login. The following table shows the Main
Menu for the administrator login. Some features are not available under the user login.
[Main Menu]
info - Information Menu
stats - Statistics Menu
cfg - Configuration Menu
oper - Operations Command Menu
boot - Boot Options Menu
maint - Maintenance Menu
diff - Show pending config changes [global command]
apply - Apply pending config changes [global command]
save - Save updated config to FLASH [global command]
revert - Revert pending or applied changes [global command]
exit - Exit [global command, always available]
Menu summary
The Main Menu displays the following submenus:
Information Menu
The Information Menu provides submenus for displaying information about the current status of the
switch: from basic system settings to VLANs, and more.
Statistics Menu
This menu provides submenus for displaying switch performance statistics. Included are port, IP,
ICMP, TCP, UDP, SNMP, routing, ARP, and DNS.
Configuration Menu
It includes submenus for configuring every aspect of the switch. Changes to configuration are not
active until explicitly applied. Changes can be saved to non-volatile memory (NVRAM).
Operations Command Menu
Operations-level commands are used for making immediate and temporary changes to switch
configuration. This menu is used for bringing ports temporarily in and out of service.
Boot Options Menu
This menu is used for upgrading switch software, selecting configuration blocks, and for resetting the
switch when necessary. This menu is also used to set the switch back to factory settings.
Maintenance Menu
This menu is used for debugging purposes, enabling you to generate a technical support dump of
the critical state information in the switch, and to clear entries in the Forwarding Database and the
Address Resolution Protocol (ARP) and routing tables.