Command Reference Guide

Error! Use the Home tab to apply 見出し 1 to the text that you want to appear here. 130
Table 138 OSPF Interface Configuration Menu options
Command
Description
retra <1-3600>
Configures the retransmit interval in seconds. The default value is 5
seconds.
key <key string>|none
Sets the authentication key to clear the password.
mdkey <1-255>|none
Assigns an MD5 key to the interface. The default is none.
enable
Enables the OSPF interface.
disable
Disables the OSPF interface. This is the default.
delete
Deletes the OSPF interface.
cur
Displays the current settings for OSPF interface.
OSPF Virtual Link configuration
Command: /cfg/l3/ospf/virt <1-3>
[OSPF Virtual Link 1 Menu]
aindex - Set area index
hello - Set hello interval in seconds
dead - Set dead interval in seconds
trans - Set transit delay in seconds
retra - Set retransmit interval in seconds
nbr - Set router ID of virtual neighbor
key - Set authentication key
mdkey - Set MD5 key ID
enable - Enable interface
disable - Disable interface
delete - Delete interface
cur - Display current OSPF interface configuration
The following table describes the OSPF Virtual Link Configuration Menu options.
Table 139 OSPF Virtual Link Configuration Menu options
Command
Description
aindex <0-2>
Configures the OSPF area index. The default is 0.
hello <1-65535>
Configures the authentication parameters of a hello packet, which is set
to be in an interval of seconds. The default value is 10 seconds.
dead <1-65535>
Configures the health parameters of a hello packet, which is set to be in
an interval of seconds. Default is 60 seconds.
trans <1-3600>
Configures the delay in transit in seconds. Default is 1 second.
retra <1-3600>
Configures the retransmit interval in seconds. Default is 5 seconds.
nbr <IP address>
Configures the router ID of the virtual neighbor.
key <password>
Configures the password (up to 8 characters) for each virtual link. Default
is none.
mdkey <1-255>|none
Sets MD5 key ID for each virtual link. Default is none.
enable
Enables OSPF virtual link.
disable
Disables OSPF virtual link. This is the default.
delete
Deletes OSPF virtual link.
cur
Displays the current OSPF virtual link settings.
OSPF Host Entry configuration
Command: /cfg/l3/ospf/host <1-128>
[OSPF Host Entry 1 Menu]
addr - Set host entry IP address
aindex - Set area index
cost - Set cost of this host entry
enable - Enable host entry
disable - Disable host entry
delete - Delete host entry
cur - Display current OSPF host entry configuration