Command Reference Guide

Error! Use the Home tab to apply 見出し 1 to the text that you want to appear here. 133
Table 144 IGMP Snoop Menu options
Command
Description
aggr disable|enable
Enables or disables IGMP Membership Report aggregation. The default is
enabled.
srcip <IP address>
Configures the source IP address used as a proxy for IGMP Group Specific
Queries.
add <1-4094>
Adds the VLAN to IGMP Snooping.
rem <1-4094>
Removes the VLAN from IGMP Snooping.
clear
Removes all VLANs from IGMP Snooping.
fastlv <1-4094>
disable|enable
Enables or disables Fastleave processing. Fastleave allows the switch to
immediately remove a port from the IGMP port list, if the host sends a Leave
message, and the proper conditions are met. This command is disabled by
default.
ena
Enables IGMP Snooping.
dis
Disables IGMP Snooping. This is the default.
cur
Displays the current IGMP Snooping parameters.
IGMPv3 Snooping configuration
Command: /cfg/l3/igmp/snoop/igmpv3
[IGMP V3 Snoop Menu]
sources - Set the number of sources to snoop in group record
v1v2 - Enable/disable snooping IGMPv1/v2 reports
exclude - Enable/disable snooping EXCLUDE mode reports
ena - Enable IGMPv3 Snooping
dis - Disable IGMPv3 Snooping
cur - Display current IGMP Snooping V3 configuration
The following table describes the IGMPv3 Snooping Configuration Menu options.
Table 145 IGMPv3 Snooping Menu options
Command
Description
sources <1-64>
Configures the maximum number of IGMP multicast sources to snoop
from within the group record. The default value is 8.
v1v2 enable|disable
Enables or disables snooping on IGMP version 1 and version 2 reports.
When disabled, the switch drops IGMPv1 and IGMPv2 reports. The
default value is enabled.
exclude enable|disable
Enables or disables snooping on IGMPv3 Exclude Reports. When
disabled, the switch ignores Exclude Reports. The default value is
enabled.
ena
Enables IGMP version 3.
dis
Disables IGMP version 3. The default value is disabled.
cur
Displays the current IGMP version 3 parameters.