Command Reference Guide

Error! Use the Home tab to apply 見出し 1 to the text that you want to appear here. 161
When the above requirements are met, use the following procedure to download the new software to
the switch.
1. At the Boot Options# prompt, enter:
Boot Options# gtimg
2. Enter the name of the switch software to be replaced:
Enter name of switch software image to be replaced
["image1"/"image2"/"boot"]: <image>
3. Enter the hostname or IP address of the FTP or TFTP server:
Enter hostname or IP address of FTP/TFTP server: <server name or IP
address>
4. Enter the name of the new software file on the server:
Enter name of file on FTP/TFTP server: <filename>
The exact form of the name will vary by TFTP server. However, the file location is normally relative to
the TFTP directory.
5. Enter the username, if you are using a FTP server:
Enter username for FTP server or hit return for TFTP server: <userID>
6. Enter the password for the FTP server (if prompted):
Enter password for username on FTP server: <password>
7. Enter the port type to use for the file transfer:
Enter the port to use for downloading the image
["mgt"|"data"]:
8. The system prompts you to confirm your request.
You should next select a software image to run, as described in the ―Selecting a Soft Image to Run‖
section.
9. If you are loading an image from which you are not currently booted, the system prompts you to
change the image.
image2 currently contains Software Version 1.0.0
that was downloaded at 15:46:36 Wed Apr 23, 2006.
New download will replace image2 with file "1.0.1_OS.img"
from TFTP server 192.168.2.4.
Confirm download operation [y/n]: y
Invoking TFTP over port 69...
Starting download...
File appears valid
Download in
progress....................................................
Image download complete (1333953 bytes)
Writing to flash...This takes about 90 seconds. Please wait
Write complete (1333953 bytes), now verifying FLASH...
Verification of new image2 in FLASH successful.
image2 now contains Software Version 1.0.1
Switch is currently set to boot software image1.
Do you want to change that to the new image2? [y/n] y
Next boot will use new software image2.
Selecting a software image to run
You can select which software image (image1 or image2) you want to run in switch memory for the next
reboot.
1. At the Boot Options# prompt, enter:
Boot Options# image