Command Reference Guide

Error! Use the Home tab to apply 見出し 1 to the text that you want to appear here. 19
[System Menu]
syslog - Syslog Menu
sshd - SSH Server Menu
radius - RADIUS Authentication Menu
tacacs+ - TACACS+ Authentication Menu
ntp - NTP Server Menu
ssnmp - System SNMP Menu
access - System Access Menu
date - Set system date
time - Set system time
timezone - Set system timezone
olddst - Set system DST for US
dlight - Set system daylight savings
idle - Set timeout for idle CLI sessions
notice - Set login notice
bannr - Set login banner
hprompt - Enable/disable display hostname (sysName) in CLI prompt
bootp - Enable/disable use of BOOTP
dhcp - Enable/disable use of DHCP on Mgmt interface
reminder - Enable/disable Reminders
cur - Display current system-wide parameters
4. Enter the following command to set the administrator password:
System# access/user/admpw
5. Enter the current administrator password at the prompt:
Changing ADMINISTRATOR password; validation required:
Enter current admin password:
NOTE: You must not forget your administrator password. If you forget your administrator password,
contact your service representative.
6. Enter the new administrator password at the prompt:
Enter new administrator password (max 128 characters):
7. Enter the new administrator password, again, at the prompt:
Re-enter new admin password:
8. Apply and save the change by entering the following commands:
System# apply
System# save
Changing the default user password
The user login has limited control of the switch. Through a user account, you can view switch information
and statistics, but you cannot make configuration changes.
The default password for the user account is user. This password cannot be changed from the user
account. Only the administrator has the ability to change passwords, as shown in the following
procedure.
1. Connect to the switch and log in using the admin password.
2. From the Main Menu, use the following command to access the Configuration Menu:
Main# cfg
3. From the Configuration Menu, use the following command to select the System Menu:
>> Configuration# sys
4. Enter the following command to set the user password: