Command Reference Guide

Error! Use the Home tab to apply 見出し 1 to the text that you want to appear here. 21
Information Menu
Introduction
You can view configuration information for the switch in the user, operator, and administrator command
modes. This chapter discusses how to use the CLI to display switch information.
Menu overview
Command: /info
[Information Menu]
sys - System Information Menu
l2 - Layer 2 Information Menu
l3 - Layer 3 Information Menu
qos - QOS Menu
acl - Show ACL information
rmon - Show RMON information
link - Show link status
port - Show port information
sfp - Show External Port SFP/XFP status
ufd - Show Uplink Failure Detection information
dump - Dump all information
The following table describes the Information Menu options.
Table 6 Information Menu options
Command
Usage
sys
Displays system information.
l2
Displays the Layer 2 Information Menu.
l3
Displays the Layer 3 Information Menu.
qos
Displays the Quality of Service (QoS) Information Menu.
acl
Displays the Access Control List (ACL) Information Menu.
rmon
Displays the Remote Monitoring Information Menu.
link
Displays configuration information about each port, including:
Port number
Port speed (10 Mb/s, 100 Mb/s, or auto)
Duplex mode (half, full, or any)
Flow control for transmit and receive (no, yes, or any)
Link status (up or down)
port
Displays port status information, including:
Port number
Whether the port uses VLAN tagging or not
Port VLAN ID (PVID)
Port name
VLAN membership
sfp
Displays SFP module information.
ufd
Displays (UFD) Uplink Failure Detection information
dump
Dumps all switch information available from the Information Menu (10K or more,
depending on your configuration).