Command Reference Guide

Error! Use the Home tab to apply 見出し 1 to the text that you want to appear here. 48
IP information
Command: /info/l3/ip
Interface information:
1: 47.80.23.243 255.255.254.0 47.80.23.255, vlan 1, up
Default gateway information: metric strict
1: 198.168.9.1, vian any, active
2: 192.168.12.235, vian any, active
Current BOOTP relay settings: OFF
0.0.0.0, 0.0.0.0
Current IP forwarding settings: OFF, dirbr disabled
Current network filter settings:
none
Current route map settings:
The following interface and default gateway information is displayed:
Interface number
IP address
IP mask
IP broadcast address
Operational status
Bootp relay settings
Network filter settings
Route map settings
IGMP multicast group information
Command: /info/l3/igmp
[IGMP Multicast Menu]
mrouter - Show IGMP Snooping Multicast Router Port information
find - Show a single group by IP group address
vlan - Show groups on a single vlan
port - Show groups on a single port
trunk - Show groups on a single trunk
detail - Show detail of a single group by IP group address
dump - Show all groups
The following table describes the commands used to display information about IGMP groups learned by
the switch.
Table 35 IGMP Multicast Group menu options
Command
Usage
mrouter
Displays the Multicast Router Menu.
find <IP address>
Displays a single IGMP multicast group by its IP address.
vlan <1-4094>
Displays all IGMP multicast groups on a single VLAN.
port <port number>
Displays all IGMP multicast groups on a single port.
trunk <1-40>
Displays all IGMP multicast groups on a single trunk group.
Detail <IP adress>
Displays details about IGMP multicast groups, including source and timer
information.
dump
Displays information for all multicast groups.