Command Reference Guide

Error! Use the Home tab to apply 見出し 1 to the text that you want to appear here. 87
The following table describes the System Configuration Menu options.
Table 79 System Configuration Menu options
Command
Usage
syslog
Displays the Syslog Menu.
sshd
Displays the SSH Server Menu.
radius
Displays the RADIUS Authentication Menu.
tacacs+
Displays the TACACS+ AuthenticationMenu.
ntp
Displays the Network Time Protocol (NTP) Server Menu.
ssnmp
Displays the System SNMP Menu.
access
Displays the System Access Menu.
date
Prompts the user for the system date.
time
Configures the system time using a 24-hour clock format.
timezone
Configures the time zone where the switch resides. You are
prompted to select your location (continent, country, region)
by the timezone wizard.
olddst disable|enable
Enables or disables use of the Daylight Saving Time (DST) rules
in effect prior to the year 2007. The default value is disabled.
dlight disable|enable
Disables or enables daylight saving time in the system clock.
When enabled, the switch will add an extra hour to the
system clock so that it is consistent with the local clock. By
default, this option is disabled.
idle <1-60>
Sets the idle timeout for CLI sessions, from 1 to 60 minutes. The
default is 5 minutes.
This setting affects both the console port and Telnet port.
notice <1-1024 character multi-
line> <'-' to end>
Displays login notice immediately before the ―Enter
password:‖ prompt. This notice can contain up to 1024
characters and new lines.
bannr <1-80 characters>
Configures a login banner of up to 80 characters. When a
user or administrator logs into the switch, the login banner is
displayed.
hprompt disable|enable
Enables or disables displaying of the host name (system
administrator‘s name) in the command line interface.
bootp disable|enable
Enables or disables the use of BOOTP. If you enable BOOTP,
the switch will query its BOOTP server for all of the switch IP
parameters. The default value is enabled.
dhcp disable|enable
Enables or disables Dynamic Host Control Protocol for setting
the management IP address on interface 256. When enabled,
the IP address obtained from the DHCP server overrides the
static IP address. The default value is enabled.
reminders disable|enable
Enables or disables reminder messages in the CLI. The default
value is enabled.
cur
Displays the current system parameters.
System host log configuration
Command: /cfg/sys/syslog
[Syslog Menu]
host - Set IP address of first syslog host
host2 - Set IP address of second syslog host
sever - Set the severity of first syslog host
sever2 - Set the severity of second syslog host
facil - Set facility of first syslog host
facil2 - Set facility of second syslog host
console - Enable/disable console output of syslog messages
log - Enable/disable syslogging of features
cur - Display current syslog settings