Command Reference Guide

Error! Use the Home tab to apply 見出し 1 to the text that you want to appear here. 102
Table 100 ACL Port Configuration commands
Command
Description
show interface port [<port number>]
access-control
Displays current ACL QoS parameters.
Command mode: All
Layer 2 configuration
The following table describes the Layer 2 Configuration commands. The following sections provide more
detailed information and commands.
Table 101 Layer 2 Configuration commands
Command
Description
vlan <1-4094>
Enter VLAN configuration mode.
Command mode: Global configuration
[no] spanning-tree
uplinkfast
Enables or disables Fast Uplink Convergence, which provides rapid
Spanning Tree convergence to an upstream switch during failover.
The default is disabled.
Note: When enabled, this feature increases bridge priorities to 65500
for all STGs except STG 128 and path cost by 3000 for all external STP
ports.
Command mode: Global configuration
spanning-tree uplinkfast
max-update-rate <10-200>
Configures the station update rate, in packets per second.
The range is 10-200. The default value is 40.
Command mode: Global configuration
show layer2
Displays current Layer 2 parameters.
Command mode: All
802.1x configuration
This feature allows you to configure this switch as an IEEE 802.1x Authenticator, to provide port-based
network access control. The following table describes the 802.1x Configuration commands.
Table 102 802.1x Configuration commands
Command
Description
dot1x enable
Globally enables 802.1x.
Command mode: Global configuration
no dot1x enable
Globally disables 802.1x. This is the default.
Command mode: Global configuration
show dot1x
Displays current 802.1x parameters.
Command mode: All