Command Reference Guide

Error! Use the Home tab to apply 見出し 1 to the text that you want to appear here. 104
802.1x Port configuration
The 802.1x port commands allow you to configure parameters that affect the selected port in the switch.
These settings override the global 802.1x parameters.
The following table describes the 802.1x Port Configuration commands.
Table 104 802.1x Port Configuration commands
Command
Description
dot1x mode {[force-unauthorized|
auto|force-authorized]}
Sets the type of access control for the port:
force-unauth : the port is unauthorized unconditionally.
auto : the port is unauthorized until it is successfully
authorized by the RADIUS server.
force-auth : the port is authorized unconditionally,
allowing all traffic.
The default value is force-auth.
Command mode: Interface port
dot1x quiet-time <0-65535>
Sets the time, in seconds, the authenticator waits before
transmitting an EAP-Request/ Identity frame to the supplicant
(client) after an authentication failure in the previous round of
authentication. The default value is 60 seconds.
Command mode: Interface port
dot1x transmit-interval
<1-65535>
Sets the time, in seconds, the authenticator waits for an EAP-
Response/Identity frame from the supplicant (client) before
retransmitting an EAP-Request/Identity frame. The default value
is 30 seconds.
Command mode: Interface port
dot1x supplicant-timeout
<1-65535>
Sets the time, in seconds, the authenticator waits for an EAP-
Response packet from the supplicant (client) before
retransmitting the EAP-Request packet to the authentication
server. The default value is 30 seconds.
Command mode: Interface port
dot1x server-timeout <1-65535>
Sets the time, in seconds, the authenticator waits for a response
from the RADIUS server before declaring an authentication
timeout. The default value is 30 seconds.
Command mode: Interface port
dot1x max-request <1-10>
Sets the maximum number of times the authenticator retransmits
an EAP-Request packet to the supplicant (client). The default
value is 2.
Command mode: Interface port
dot1x re-authentication-interval
<1-604800>
Sets the time, in seconds, the authenticator waits before re-
authenticating a supplicant (client) when periodic re-
authentication is enabled. The default value is 3600 seconds.
Command mode: Interface port
[no] dot1x re-authenticate
Sets the re-authentication status to on or off. The default value
is off.
Command mode: Interface port
default dot1x
Resets the global 802.1x parameters to their default values.
Command mode: Interface port
show dot1x
Displays current global 802.1x parameters.
Command mode: All
show interface port {<1-16,
18-21>} dot1x
Displays current 802.1x parameters on the specified port
Command mode: All