Command Reference Guide

Error! Use the Home tab to apply 見出し 1 to the text that you want to appear here. 121
Routing Information Protocol configuration
The RIP commands are used for configuring Routing Information Protocol parameters. This option is turned
off by default.
The following table describes the basic RIP Configuration commands. The following section provides more
detailed information and commands.
Table 129 RIP Configuration commands
Command
Description
router rip
Enter router RIP configuration mode.
Command mode: Global configuration
timers update <1-120>
Configures the time interval for sending for RIP table updates, in
seconds.
The default value is 30 seconds.
Command mode: Router RIP
enable
Globally turns RIP on.
Command mode: Router RIP
no enable
Globally turns RIP off. This is the default.
Command mode: Router RIP
show ip rip
Displays the current RIP configuration.
Command mode: All
RIP Interface configuration
The RIP commands are used for configuring Routing Information Protocol parameters. This option is turned
off by default.
NOTE: Do not configure RIP version 1 parameters if your routing equipment uses RIP version 2.
The following table describes the RIP Interface Configuration commands.
Table 130 RIP Interface Configuration commands
Command
Description
ip rip version {1|2|both}
Configures the RIP version used by this interface.
The default value is version 2.
Command mode: Interface IP
[no] ip rip supply
When enabled, the switch supplies routes to other routers. This
command is enabled by default.
Command mode: Interface IP
[no] ip rip listen
When enabled, the switch learns routes from other routers. This
command is enabled by default.
Command mode: Interface IP
[no] ip rip poison
When enabled, the switch uses split horizon with poisoned reverse.
When disabled, the switch uses only split horizon. This command is
disabled by default.
Command mode: Interface IP
[no] ip rip split-horizon
Enables or disables split horizon. The default value is enabled.
Command mode: Interface IP
[no] ip rip triggered
Enables or disables Triggered Updates. Triggered Updates are used to
speed convergence. When enabled, Triggered Updates force a router
to send update messages immediately, even if it is not yet time for the
update message. The default value is enabled.
Command mode: Interface IP
[no] ip rip multicast-
updates
Enables or disables multicast updates of the routing table (using
address 224.0.0.9). The default value is enabled.
Command mode: Interface IP