Command Reference Guide

Error! Use the Home tab to apply 見出し 1 to the text that you want to appear here. 126
Table 135 OSPF Interface Configuration commands
Command
Description
ip ospf enable
Enables the OSPF interface.
Command mode: Interface IP
no ip ospf enable
Disables the OSPF interface. The default is disabled.
Command mode: Interface IP
no ip ospf
Deletes the OSPF interface.
Command mode: Interface IP
show interface ip <1-250>
ospf
Displays the current settings for OSPF interface.
Command mode: All
OSPF Virtual Link configuration
The following table describes the OSPF Virtual Link Configuration commands.
Table 136 OSPF Virtual Link Configuration commands
Command
Description
area-virtual-link <1-3> area <0-
2>
Configures the OSPF area index. The default is 0.
Command mode: Router OSPF
area-virtual-link <1-3> hello-
interval <1-65535>
Configures the authentication parameters of a hello packet,
which is set to be in an interval of seconds. The default is 10
seconds.
Command mode: Router OSPF
area-virtual-link <1-3> dead-
interval <1-65535>
Configures the health parameters of a hello packet, which is set
to be in an interval of seconds. Default is 60 seconds.
Command mode: Router OSPF
area-virtual-link <1-3> transit-
delay <1-3600>
Configures the delay in transit in seconds. Default is 1 second.
Command mode: Router OSPF
area-virtual-link <1-3>
retransmit-interval <1-3600>
Configures the retransmit interval in seconds. Default is 5
seconds.
Command mode: Router OSPF
area-virtual-link <1-3> neighbor-
router <IP address>
Configures the router ID of the virtual neighbor. Default is 0.0.0.0
Command mode: Router OSPF
[no] area-virtual-link <1-3> key
<key string>
Configures the password (up to 8 characters) for each virtual
link. Default is none.
Command mode: Router OSPF
[no] area-virtual-link <1-3>
message-digest-key <1-255>
Sets MD5 key ID for each virtual link. Default is none.
Command mode: Router OSPF
area-virtual-link <1-3> enable
Enables OSPF virtual link.
Command mode: Router OSPF
no area-virtual-link <1-3> enable
Disables OSPF virtual link. This is the default.
Command mode: Router OSPF
no area-virtual-link <1-3>
Deletes OSPF virtual link.
Command mode: Router OSPF
show ip ospf area-virtual-link
<1-3>
Displays the current OSPF virtual link settings.
Command mode: All
OSPF Host Entry configuration
The following table describes the OSPF Host Entry Configuration commands.
Table 137 OSPF Host Entry Configuration commands
Command
Description