Command Reference Guide

Error! Use the Home tab to apply 見出し 1 to the text that you want to appear here. 131
Bootstrap Protocol Relay configuration
Bootstrap Protocol (BOOTP) Relay is used to allow hosts to obtain their configurations from a Dynamic
Host Configuration Protocol (DHCP) server. The BOOTP configuration enables the switch to forward a
client request for an IP address to two DHCP/BOOTP servers with IP addresses that have been configured
on this switch.
BOOTP relay is turned off by default.
The following table describes the BOOTP Configuration commands.
Table 147 BOOTP Configuration commands
Command
Description
[no] ip bootp-relay
{server1|server2} <IP
address>
Sets the IP address of the first or second BOOTP server.
Command mode: Global configuration
ip bootp-relay enable
Globally turns on BOOTP relay.
Command mode: Global configuration
no ip bootp-relay enable
Globally turns on BOOTP relay. This is the default.
Command mode: Global configuration
show ip bootp-relay
Displays the current BOOTP relay configuration.
Command mode: All