Command Reference Guide

Error! Use the Home tab to apply 見出し 1 to the text that you want to appear here. 136
VRRP Interface configuration
These commands are used for configuring VRRP authentication parameters for the IP interfaces used with
the virtual routers. The interface-number represents the IP interface on which authentication parameters
must be configured.
The following table describes the VRRP Interface Configuration commands.
Table 153 VRRP Interface Configuration commands
Command
Description
interface <1-249>
authentication
{password|none}
Defines the type of authentication that will be used: none (no
authentication), or password (password authentication). The default
is none.
Command mode: Router VRRP
interface <1-249> password
{password|none}
Defines a plain text password up to eight characters long. This
password will be added to each VRRP packet transmitted by this
interface when password authentication is chosen.
Command mode: Router VRRP
no interface <1-249>
Clears the authentication configuration parameters for this IP interface.
The IP interface itself is not deleted.
Command mode: Router VRRP
show ip vrrp interface <1-
249>
Displays the current configuration for this IP interface‘s authentication
parameters.
Command mode: All
VRRP Tracking configuration
These commands are used for setting weights for the various criteria used to modify priority levels during
the master router election process. Each time one of the tracking criteria is met, the priority level for the
virtual router is increased.
The following table describes the VRRP Tracking Configuration commands.
Table 154 VRRP Tracking Configuration commands
Command
Description
tracking-priority-increment
virtual-routers <0-254>
Defines the priority increment value (0 through 254) for virtual routers in
master mode detected on this switch. The default value is 2.
Command mode: Router VRRP
tracking-priority-increment
interfaces <0-254>
Defines the priority increment value (0 through 254) for active IP
interfaces detected on this switch. The default value is 2.
Command mode: Router VRRP
tracking-priority-increment
ports <0-254>
Defines the priority increment value (0 through 254) for active ports on
the virtual router‘s VLAN. The default value is 2.
Command mode: Router VRRP
show ip vrrp tracking-
priority-increment
Displays the current configuration of priority tracking increment values.
Command mode: All
NOTE: These priority tracking options only define increment values. These options do not affect the
VRRP master router election process until options under VRRP Virtual Router Priority Tracking are
enabled.