Command Reference Guide

Error! Use the Home tab to apply 見出し 1 to the text that you want to appear here. 139
Table 157 Ethernet Filter Configuration commands
Command
Description
default access-control list <ACL
number> ethernet
Resets Ethernet parameters for the ACL to their default
values.
Command mode: Global configuration
show access-control list <ACL number>
ethernet
Displays the current Ethernet parameters for the ACL.
Command mode: All
ACL IP Version 4 Filter configuration
These commands allow you to define IPv4 matching criteria for an ACL. The following table describes the
IP version 4 Filter Configuration commands.
Table 158 IPv4 Filter Configuration commands
Command
Description
[no] access-control list
<ACL number> ipv4 source-ip-
address <IP address> [<IP
mask>]
Defines a source IP address for the ACL.
Command mode: Global configuration
[no] access-control list
<ACL number> ipv4
destination-ip-address <IP
address> [<IP mask>]
Defines a destination IP address for the ACL.
Command mode: Global configuration
[no] access-control list
<ACL number> ipv4 protocol
<0-255>
Defines an IP protocol for the ACL. If defined, traffic from the specified
protocol matches this filter. Specify the protocol number. Listed below
are some of the well-known protocols.
Number Name
1 icmp
2 igmp
6 tcp
17 udp
89 ospf
112 vrrp
Command mode: Global configuration
[no] access-control list
<ACL number> ipv4 type-of-
service <0-255>
Defines a Type of Service value for the ACL. For more information on
ToS, see RFC 1340 and 1349.
Command mode: Global configuration
default access-control list
<ACL number> ipv4
Resets the IPv4 parameters for the ACL to their default values.
Command mode: Global configuration
show access-control list
<ACL number> ipv4
Displays the current IPV4 parameters.
Command mode: All