Command Reference Guide

Error! Use the Home tab to apply 見出し 1 to the text that you want to appear here. 141
ACL Metering configuration
The following table describes the ACL Metering Configuration commands.
Table 161 ACL Metering Configuration commands
Command
Description
access-control list <ACL
number> meter committed-rate
<1000-10000000>
Configures the committed rate, in Kilobits per second. The committed
rate must be a multiple of 1000. The default is 1000.
Command mode: Global configuration
access-control list <ACL
number> meter maximum-burst-
size <32-4096>
Configures the maximum burst size, in Kilobits. Enter one of the following
values for mbsize: 32, 64, 128, 256, 512, 1024, 2048, 4096
The default is 32.
Command mode: Global configuration
[no] access-control list
<ACL number> meter enable
Enables or disables Metering on the ACL. The default is disabled.
Command mode: Global configuration
access-control list <ACL
number> meter action
{drop|pass}
Configures the ACL Meter to either drop or pass out-of-profile traffic.
Command mode: Global configuration
default access-control list
<ACL number> meter
Reset ACL Metering parameters to their default values.
Command mode: Global configuration
show access-control list
<ACL number> meter
Displays the current ACL metering parameters.
Command mode: All
ACL Re-mark configuration
You can choose to re-mark IP header data for the selected ACL. You can configure different re-mark
values, based on whether packets fall within the ACL Metering profile, or out of the ACL Metering profile.
The following table describes the ACL Re-mark Configuration commands.
Table 162 ACL Re-mark Configuration commands
Command
Description
[no] access-control list <ACL
number> re-mark
Assign an ACL for DSCP Re-marking. You have to configure
the additional option for this command. See the "In-Profile,
Out-of-Profile " section.
Command mode: Global configuration
default access-control list <ACL
number> re-mark
Reset ACL Re-mark parameters to their default values.
Command mode: Global configuration
show access-control list <ACL
number> re-mark
Displays the current ACL re-mark parameters.
Command mode: All
ACL Re-mark In-Profile configuration
The following table describes the ACL Re-mark In-Profile Configuration commands.
Table 163 ACL Re-mark In-Profile Configuration commands
Command
Description
[no] access-control list <ACL
number> re-mark in-profile
dscp <0-63>
Sets the DiffServ Code Point (DSCP) of In-Profile packets to the
selected value (0-63).
Command mode: Global configuration
default access-control list
<ACL number> re-mark
Resets the update DSCP parameters to their default values.
Command mode: Global configuration
show access-control list <ACL
number> re-mark
Displays the current ACL re-mark parameters.
Command mode: All