Command Reference Guide

Error! Use the Home tab to apply 見出し 1 to the text that you want to appear here. 150
Table 179 Operations-Level Port 802.1x commands
Command
Description
interface port {<port
number>} dot1x re-
authenticate
Re-authenticates the supplicant (client) attached to the port. This
command only applies if the port‘s 802.1x mode is configured as auto.
Command Mode: All
Operations-level VRRP options
Operations-level VRRP options are described in the following table.
Table 180 Operations-Level VRRP commands
Command
Description
router vrrp backup
<1-250>
Forces the specified master virtual router on this switch into backup mode. This is
generally used for passing master control back to a preferred switch once the
preferred switch has been returned to service after a failure. When this command
is executed, the current master gives up control and initiates a new election by
temporarily advertising its own priority level as 0 (lowest). After the new election,
the virtual router forced into backup mode by this command will resume master
control in the following cases:
This switch owns the virtual router (the IP addresses of the virtual router and its
IP interface are the same)
This switch‘s virtual router has a higher priority and preemption is enabled.
There are no other virtual routers available to take master control.
Command Mode: All