Command Reference Guide

Error! Use the Home tab to apply 見出し 1 to the text that you want to appear here. 29
Link Aggregation Control Protocol information
The following table describes the Link Aggregation Control Protocol information commands.
Table 19 LACP information commands
Command
Usage
show interface port <port number> lacp
information
Displays LACP aggregator information for the port.
Command mode: All
show lacp
Displays LACP information for the port.
Command mode: All
show lacp information
Displays all LACP information parameters.
Command mode: All
LACP dump
The following command displays LACP information:
show lacp information
Command mode: All
>> LACP# dump
port lacp adminkey operkey selected prio attached trunk
aggr
----------------------------------------------------------------------
1 off 1 1 n 32768 -- --
2 off 2 2 n 32768 -- --
3 off 3 3 n 32768 -- --
4 off 4 4 n 32768 -- --
5 off 5 5 n 32768 -- --
6 off 6 6 n 32768 -- --
7 off 7 7 n 32768 -- --
8 off 8 8 n 32768 -- --
LACP dump includes the following information for each port in the switch:
lacp—Displays the port‘s LACP mode (active, passive, or off)
adminkey—Displays the value of the port‘s adminkey.
operkey—Shows the value of the port‘s operational key.
selected—Indicates whether the port has been selected to be part of a Link Aggregation Group.
prio—Shows the value of the port priority.
attached aggr—Displays the aggregator associated with each port.
trunk—This value represents the LACP trunk group number.