Command Reference Guide

Error! Use the Home tab to apply 見出し 1 to the text that you want to appear here. 31
Table 20 802.1x information
Field
Description
Backend Auth State
Displays the Backend Authorization State. The Backend
Authorization state can be one of the following:
initialize
request
response
success
fail
timeout
idle
Spanning Tree information
The following table describes the Spanning Tree Protocol (STP) information commands.
Table 21 STP information commands
Command
Usage
show spanning-tree stp <1-128>
Displays information about the spanning tree group.
Command mode: All
show spanning-tree stp <1-128> bridge
Displays STP bridge information.
Command mode: All
show spanning-tree stp <1-128>
information
Displays STP information.
Command mode: All
show spanning-tree
Displays all STP information.
Command mode: All
The following command displays Spanning Tree information:
show spanning-tree
Command mode: All
------------------------------------------------------------------
upfast disabled, update 40
------------------------------------------------------------------
Spanning Tree Group 1: On (STP/PVST+)
VLANs: 1
Current Root: Path-Cost Port Hello MaxAge FwdDel
8000 00:02:a5:d1:0f:ed 8 20 2 20 15
Parameters: Priority Hello MaxAge FwdDel Aging
32768 2 20 15 300
Port Priority Cost FastFwd State Designated Bridge Des Port
---- -------- ---- -------- ---------- --------------------- -------
1 0 0 n FORWARDING *
2 0 0 n FORWARDING *
3 0 0 n FORWARDING *
The switch software uses the IEEE 802.1D Spanning Tree Protocol (STP). If RSTP/MSTP is turned on, see the
―Rapid Spanning Tree information‖ section for Spanning Tree Group information. In addition to seeing if
STP is enabled or disabled, you can view the following STP bridge information:
Status of Uplink Fast (upfast)
Current root MAC address
Path cost
Port
Hello Time