Command Reference Guide

Error! Use the Home tab to apply 見出し 1 to the text that you want to appear here. 85
System configuration
These commands allow you to configure switch management parameters such as user and administrator
privilege mode passwords, browser-based management settings, and management access list.
The following table describes the System Configuration commands.
Table 77 System Configuration commands
Command
Usage
system date <yyyy> <mm> <dd>
Prompts the user for the system date.
Command mode: Global configuration
system time <hh>:<mm>:<ss>
Configures the system time using a 24-hour clock format.
Command mode: Global configuration
system timezone <0-374>
Configures the time zone where the switch resides. You are
prompted to select your location (continent, country, region)
by the timezone wizard.
Command mode: Global configuration
system daylight
Disables or enables daylight saving time in the system clock.
When enabled, the switch will add an extra hour to the
system clock so that it is consistent with the local clock. By
default, this option is disabled.
Command mode: Global configuration
system idle <1-60>
Sets the idle timeout for CLI sessions, from 1 to 60 minutes. The
default is 5 minutes.
This setting affects both the console port and Telnet port.
Command mode: Global configuration
[no] system notice <1-1024
characters multi-line> <’-‘ to
end>
Displays login notice immediately before the ―Enter
password:‖ prompt. This notice can contain up to 1024
characters and new lines.
Command mode: Global configuration
[no] banner <1-80 characters>
Configures a login banner of up to 80 characters. When a
user or administrator logs into the switch, the login banner is
displayed.
Command mode: Global configuration
[no] hostname <string>
Enables or disables displaying of the host name (system
administrator‘s name) in the command line interface.
Command mode:: Global configuration
[no] system bootp
Enables or disables the use of BOOTP. If you enable BOOTP,
the switch will query its BOOTP server for all of the switch IP
parameters. The default value is enabled.
Command mode: Global configuration
[no] system dhcp
Enables or disables Dynamic Host Control Protocol for setting
the management IP address on interface 256. When enabled,
the IP address obtained from the DHCP server overrides the
static IP address. The default value is enabled.
Command mode: Global configuration
[no] enable <string>
Allows administrators to assign the Privilege EXEC password.
The password will be required to enter Privilege EXEC mode.
The default value is disabled.
Command mode: Global configuration
show system
Displays the current system parameters.
Command mode: All except User EXEC