Handbook

Error! Use the Home tab to apply 見出し 1 to the text that you want to appear here. 10
>> # /cfg/l3/if 250 (Select IP interface 250)
>> IP Interface 250# addr 205.21.17.3(Assign IP address for the interface)
Current IP address: 0.0.0.0
New pending IP address: 205.21.17.3
Pending new subnet mask: 255.255.255.0
. . . . . . . . . . . .
>> IP Interface 250# ena (Enable IP interface 250)
4. If necessary, configure default gateway.
5. Configuring the default gateways allows the switch to send outbound traffic to the routers.
>> IP Interface 250# ../gw 254 (Select default gateway 254)
>> Default gateway 254# addr 205.21.17.1 (Assign IP address for a router)
>> Default gateway 254# ena (Enable default gateway 254)
6. Apply, verify, and save the configuration.
>> Default gateway 254# apply (Apply the configuration)
>> Default gateway 254# save (Save the configuration)
>> # /cfg/dump (Verify the configuration)
NOTE: Disable dhcp on this switch when the IP address on interface 250 is set manually. When
the dhcp is enabled, the IP address obtained from the DHCP server overrides the static IP
address configured manually.
Using the Browser-based Interface
By default, the Browser-based Interface (BBI) protocol is enabled on the switch. The Browser-based
Interface (BBI) provides access to the common configuration, management and operation features of
the switch through your Web browser. For more information, see the N8406-026 10Gb Intelligent L3 Switch
Browser-based Interface Reference Guide.
The BBI is organized at a high level as follows:
Configuration — These menus provide access to the configuration elements for the entire switch.
System — Configure general switch configuration elements.
Switch ports — Configure switch ports and related features.
Port-Based Port Mirroring — Configure mirrored ports and monitoring ports.
Layer 2 — Configure Layer 2 features, including trunk groups, VLANs, and Spanning Tree
Protocol.
RMON Menu — Configure Remote Monitoring (RMON) functions.
Layer 3 — Configure all of the IP related information, including IGMP Snooping.
QoS — Configure Quality of Service features.
Access Control — Configure Access Control Lists and Groups.
Uplink Failure Detection — Configure a Failover Pair of Links to Monitor and Links to Disable.
Statistics — These menus provide access to the switch statistics and state information.
Dashboard — These menus display settings and operating status of a variety of switch features.
Using Simple Network Management Protocol
The switch software provides SNMP v1.0 and SNMP v3.0 support for access through any network
management software.