User's Manual

NDA-24298 CHAPTER 4
Page 211
Issue 1
ANPDL : Assignment of Numbering Plan Data for Local Data Memory
ANPDL: Assignment of Numbering Plan Data for Local Data Memory
1. General
This command assigns the minimum number of digits needed to determine the service which is required to the
first digit received (pre-translation).
2. Precautions
1. This command is used for the Business Application.
2. The applicable tenant number (TN) range is designated by the ASYD command, SYS1, INDEX8.
Enter the tenant number this command effects.
If data in this command is common for all tenants (ASYDL command, SYS1, INDEX800, bit2=1), assign
TN parameter as data “1” for all tenants.
3. Use this command to assign the numbering data for the operator call and the priority call (terminating to
ATT) in the Fusion network.
4. The numbering data for Telephone numbers may be programmed by this command, however, those
Telephone numbers are available in the self node only.
Telephone numbers available within the Fusion network are to be programmed at Network Control Node
(NCN) using the ANPDN and ASPAN commands. For more details, see the NEAX2400 IPX Fusion
Network System Manual.
5. The system data assignment (ASYDL, SYS1, INDEX 514, bit0=1) is necessary when using the ANPDL
command.