User's Manual

CHAPTER 4 NDA-24298
Page 596
Issue 1
ATGLL : Assignment of Trunk Group Busy Lamp Data for LDM
ATGLL : Assignment of Trunk Group Busy Lamp Data for LDM
1. General
This command is used to readout/assign/delete the controlling data of Trunk Group Busy Lamp which is
accommodated on the Attendant Console. This data is written in Local Data Memory (LDM).
2. Precautions
1. The number of Attendant Consoles should be assigned by the ASYD command, SYS1, INDEX9.
2. The Trunk Group Busy Lamp lit when the trunk routes specified by the LGRT parameter of this command
are engaged.
3. The number of Trunk Group Busy Lamps to be applied (capable TGN data range) is assigned by the
ASYD command, SYS1, INDEX15, bit0-3.
3. Data Entry Instructions
ATTTENDANT
NUMBER
(ATN)
1-30
LOGICAL ROUTE
NUMBER
(LGRT)
1-899
TRUNK GROUP
BUSY LAMP
NUMBER
(TGN)
1-10
LGRT DATA
(DATA)
0/1
REMARKS
ATN
Enter the Attendant Console Number assigned
by the ATRK command.
LGRT
Enter the logical route number
composed the Trunk Group (TGN).
TGN
Enter the Trunk Group Busy Lamp
Number on the Attendant Console.
DATA
0 = Not registration
1= Registration