User's Manual

CHAPTER 4 NDA-24298

Page 724

Issue 1

AISD_T : Assignment of Individual Speed Calling Data – Telephone Number

1. General

This command is used to assign the speed dial number (of the Speed Calling - Station service feature) for a

station, instead of a station user’s registration. The station data of AISD command can be assigned by using

Telephone Number.

2. Precautions

1. Only the Telephone Numbers assigned by the ALGSN command can be used. Telephone Numbers by the

ALGSL command is not available in this command.

2. In case logging in to a LN, only the Telephone Numbers allocated to the stations within the logged-in

node can be used in this command. Also, when logging in to the NCN, the data memory of the whole

nodes in the network is to be written.

3. The applicable tenant number (TN) range is designated by the ASYD command, SYS1, INDEX 8.

4. The Station designated by Telephone Number on this command should be assigned as a master station

(MST) by the AISA/AISA_T command beforehand.

5. The data range of the SPD parameter on this command varies depending on the number of memory-blocks

assigned by the AISA/AISA_T command. (One memory-block contains ten memories which store ten

different speed dialing numbers.)