User's Manual

CHAPTER 4 NDA-24298

Page 58

Issue 1

ATIMN : Assignment of Date and Time for NDM

ATIMN: Assignment of Date and Time for NDM

1. General

This command sets the clock information for all systems within the Fusion network. The time data assigned by

this command is adjusted according to each LN’s time difference data assigned by the ATDF command, before

updating the NDM at each LN. The completion of time data assignment for each LN is displayed on the MAT.

2. Precautions

1. Prior to this command, the time difference data for all nodes must be assigned to the NCN using the ATDF

command.

2. The clock is assigned in military time.

3. Clock information assigned in this command is necessary for the following purposes:

(a) To indicate time for D

term

and ATT (Desk Console/Hotel Console)

(b) To specify the time for changing the route pattern for LCR

(d) To specify the time for outgoing calls or for refusing incoming calls

(e) To specify the start time for the routing diagnosis

(f) To specify a length of time for Traffic Measurement

(g) SMDR

4. The system automatically takes the leap year into account.

5. Clock information is executed when “Y” is entered in WRT? field and the Enter key pressed.