User's Manual

CHAPTER 4 NDA-24298
Page 956
Issue 1
ALGSN : Assignment of Telephone Station Data for NDM
ALGSN: Assignment of Telephone Station Data for NDM
1. General
This command assigns the related data of the Telephone Number (TELN) corresponding to the physical station.
The data assigned by this command is written in Network Data Memory (NDM) of the Network Control Node
(NCN), updating the NDM at each Local Node (LN).
2. Precautions
1. The ALGSN command is used to assign the Telephone Number (TELN) for a Network Control Node
(NCN).
2. The TYPE parameter allows the user to choose the programming method of the physical station.
TYPE = 1 (LENS): Telephone number to be given to the LENS
TYPE = 2 (STN): Telephone number to be given to the station
3. The system data assignment (ASYDN, SYS 1, INDEX 514, bit1 = 1) is needed to provide the Network
Data Memory (NDM).
4. When the parameter TYPE is “1” (LENS is used to specify the physical station number), the assignment
of the Fusion Point Code (FPC) entered by the AFMU command is required.
5. For detailed information, see the NEAX2400 IPX Fusion Network System Manual.
6. The applicable Tenant Number (TN) range is designated by the ASYDN command, SYS 1, INDEX 8. If
the data in this command is common for all tenants (ASYDN, SYS 1, INDEX 800, bit0 = 1), assign TN
parameter as data “1” for all tenants.