User's Manual

CHAPTER 8 NDA-24300
Page 522
Issue 1
ALLC: Assignment of Line Load Control
ALLC:
Assignment of Line Load Control
1. Functional Outline
This command is used to designate start and stop of line load control.
2. Parameters
Input data
ALL/ONE: Operation Mode Selection
O/A=Only One LP/All LPs 2 is not valid for 1IMG-system.
LP: Local Partition (LP) Number
Note
The data is designated as 00 for 1IMG-system.
STATUS: Line Load Control Status (0-3)
0=Stop Line Load Control
1=Start Line Load Control
2=Automatic Line Load Control is in effect (display only)
3=Status of all LPs do not match (display only)
Note:
This parameter appears when “O (only on LP)” is set in “ALL/ONE” input data.