User's Manual

ND-70185 (E) CHAPTER 5
Page 91
Revision 3.0
DATA PROGRAMMING
Assignment of FCH Related Data
STEP 1: ANPDN/ANPDL
Note
Assign the first digit of the LCR/LCRS access code. When the access code is common to all nodes,
use the ANPDN command. When the access code is assigned for each node, use the ANPDL com-
mand.
TN=1 1st DC=8 CI=N (Normal) NND=1
TN=1 1st DC=8 CI=H (Hooking) NND=1
STEP 2: ASPAN/ASPAL
Note
Assign the LCR/LCRS access code for a dummy route number. When the access code is common to
all nodes, use the ASPAN command. When the access code is assigned for each node, use the ASPAL
command.
ACC=8 CI=N (Normal) SRV=LCR/LCRS LGRT=Dummy route number
ACC=8 CI=H (Hooking) SRV=LCR/LCRS LGRT=Dummy route number
STEP 3: AMND
Using AMND, assign the Maximum Necessary Digits to be received by Register (ORT) circuit.
DC=8110 MND=8
STEP 4: ARNPL
Using ARNPL, assign the access code for each external trunk route, but not for a dummy route.
RT=10 ACC=8
RT=200 ACC=9
Note:
When entering the data in STEP 1, 2, 6, 7 and 8, do not mix the commands for LDM and NDM. Write the
data on the same data memory as shown below:
• When writing the data on the LDM:
ANPDL → ASPAL → AFRSL → AOPRL → AADCL
(STEP 1) (STEP 2) (STEP 6) (STEP 7) (STEP8)
• When writing the data on the NDM:
ANPDN → ASPAN → AFRSN → AOPRN → AADCN
(STEP 1) (STEP 2) (STEP 6) (STEP 7) (STEP8)