Operation Manual

115
8. Using Optional Lenses
SELECT
SELECT
LEFT
RIGHT
DOWN
UP
PC CARD
LAMP
STATUS
POWER
SOURCE
AUTO ADJUST
3D REFORM
ON/STAND BY
SELECT
PC CARD
LAMP
STATUS
POWER
SOURCE
AUTO ADJUST
3D REFORM
ON/STAND BY
SELECT
LEFT
RIGHT
DOWN
UP
2. Pull out the existing lens slowly.
Remove the existing lens from the projector.
1. Rotate the lens counterclockwise while strongly pushing the
LENS RELEASE button all the way in.
The existing lens will be disengaged.
NOTE: If the lens cannot be removed even by using the LENS RELEASE but-
ton, the anti-theft screw for lens may be used to secure the lens.
If such is the case, remove the anti-theft screw first. ( → page 116)
LENS RELEASE
Button
 Replacing with Optional Lens
CAUTION
• Do not give a shock or excessive load to the projector or the lens components as the projector and lens components
contain precision parts.
• When shipping the projector with the optional lens, remove the optional lens before shipping the projector. The
lens and the lens shift mechanism may encounter damage caused by improper handling during transportation.
• Before removing or installing the lens, be sure to turn off the projector, wait until the cooling fans stop, and turn off
the main power switch.
• Do not touch the lens surface when removing or installing the lens.
• Keep fingerprints, dust or oil off the lens surface. Do not scratch the lens surface.
•Work on a level surface with a soft cloth under it to avoid scratching.
• If you remove and store the lens, attach the lens cap to the projector to keep off dust and dirt.
• Please heed the following information if you own two or more NP2000/NP1000 projectors and may interchange
the standard lenses.
When replacing the standard lens (with an optional lens) and then re-installing the standard lens back into the
projector, the standard lens must go back to its original projector from which it was removed.
If you remove the standard lens from one NP2000/NP1000 projector and re-install it into another NP2000/NP1000
projector, performance may be compromised.
Be sure to use the standard lens in combination with its original factory-adjusted projector.