Operation Manual
Table Of Contents
- INDEX
- Front cover
- Important Information
- Table of Contents
- 1. Introduction
- 2. Installation and Connections
- 3. Projecting an Image (Basic Operation)
- 4. Convenient Features
- (1) Turning Off the Image and Sound
- (2) Freezing a Picture
- (3) Enlarging and Moving a Picture
- (4) Changing Lamp Mode
- (5) Getting Integrated Help
- (6) Using a USB Mouse
- (7) Using the Optional Remote Mouse Receiver (NP01MR)
- (8) Correcting Horizontal and Vertical Keystone Distortion [CORNERSTONE]
- (9) Displaying Two Pictures at the Same Time
- (10) Preventing Unauthorized Use of the Projector
- (11) Limiting Access Level to Available Menu Items
- (12) Operation Using an HTTP Browser
- (13) Projecting Your Computer’s Screen Image from the Projector via a Network [NETWORK PROJECTOR]
- (14) Using the Projector to Operate Your Computer via a Network [REMOTE DESKTOP]
- 5. Using the Viewer
- 6. Using On-Screen Menu
- 7. Maintenance
- 8. Using Optional Lenses
- 9. Appendix
- (1) Troubleshooting
- (2) Specifications
- (3) Cabinet Dimensions
- (4) Screen Size and Projection Distance
- (5) Pin Assignments of D-Sub COMPUTER 1 Input Connector
- (6) Compatible Input Signal List
- (7) PC Control Codes and Cable Connection
- (8) Removing and Attaching the USB Wireless LAN Unit
- (9) Troubleshooting Check List
- (10) TravelCare Guide
124
6. Using On-Screen Menu
Menu Descriptions & Functions [RESET]
Returning to Factory Default
The Reset feature allows you to change adjustments and settings to the factory preset for sources by the following
methods:
[CURRENT SIGNAL]
Resets the adjustments for the current signal to the factory preset levels.
All the items in [ADJUST] can be reset.
[ALL DATA]
Reset all the adjustments and settings for all the signals to the factory preset except [ENTRY LIST], [LANGUAGE],
[BACKGROUND], [FILTER MESSAGE], [MULTI-SCREEN COMP.], [SECURITY SETTINGS], [NETWORK SET-
TINGS], [COMMUNICATION SPEED], [STANDBY MODE], [CONTROL ID], [FAN MODE], [DATE, TIME PRE-
SET], [LAMP LIFE REMAINING], [LAMP HOURS USED] and [FILTER HOURS USED].
[ALL DATA (INCLUDING ENTRY LIST)]
Reset all the adjustments and settings for all the signals to the factory preset except [LANGUAGE], [BACK-
GROUND], [FILTER MESSAGE], [MULTI-SCREEN COMP.], [SECURITY SETTINGS], [NETWORK SETTINGS],
[COMMUNICATION SPEED], [STANDBY MODE], [CONTROL ID], [FAN MODE], [DATE, TIME PRESET], [LAMP
LIFE REMAINING], [LAMP HOURS USED] and [FILTER HOURS USED].
Also deletes all the signals in the [ENTRY LIST] and returns to the factory preset.
NOTE: Locked signals in Entry List cannot be reset.
Clearing Lamp Hour Meter [CLEAR LAMP HOURS]
Resets the lamp clock back to zero.
NOTE: Elapsed time of the lamp use will not be affected even when [RESET] is done from the menu.
NOTE: The projector will turn off and go into standby mode when you continue to use the projector for another 100 hours after the
lamp has reached the end of its life. In this condition you cannot clear the lamp hour meter on the menu. If this happens, press the
HELP button on the remote control for 10 seconds to reset the lamp clock back to zero. Do this only after replacing the lamp.
Resetting the Filter Usage Hours [CLEAR FILTER HOURS]
Resets the filter usage back to zero.
NOTE: Elapsed time of the filter use will not be affected even when [RESET] is done from the menu.