Operation Manual
Table Of Contents
- INDEX
- Front cover
- Important Information
- Table of Contents
- 1. Introduction
- 2. Installation and Connections
- 3. Projecting an Image (Basic Operation)
- 4. Convenient Features
- (1) Turning Off the Image and Sound
- (2) Freezing a Picture
- (3) Enlarging and Moving a Picture
- (4) Changing Lamp Mode
- (5) Getting Integrated Help
- (6) Using a USB Mouse
- (7) Using the Optional Remote Mouse Receiver (NP01MR)
- (8) Correcting Horizontal and Vertical Keystone Distortion [CORNERSTONE]
- (9) Displaying Two Pictures at the Same Time
- (10) Preventing Unauthorized Use of the Projector
- (11) Limiting Access Level to Available Menu Items
- (12) Operation Using an HTTP Browser
- (13) Projecting Your Computer’s Screen Image from the Projector via a Network [NETWORK PROJECTOR]
- (14) Using the Projector to Operate Your Computer via a Network [REMOTE DESKTOP]
- 5. Using the Viewer
- 6. Using On-Screen Menu
- 7. Maintenance
- 8. Using Optional Lenses
- 9. Appendix
- (1) Troubleshooting
- (2) Specifications
- (3) Cabinet Dimensions
- (4) Screen Size and Projection Distance
- (5) Pin Assignments of D-Sub COMPUTER 1 Input Connector
- (6) Compatible Input Signal List
- (7) PC Control Codes and Cable Connection
- (8) Removing and Attaching the USB Wireless LAN Unit
- (9) Troubleshooting Check List
- (10) TravelCare Guide
129
7. Maintenance
5. Connect the supplied power cable, turn on the Main Power switch and turn on the projector.
6. Finally, select the menu
→
[RESET]
→
[CLEAR LAMP HOURS] to reset the lamp life remaining and lamp
usage hours.
NOTE: When you continue to use the projector for another 100 hours after the lamp has reached the end of its life, the projector
cannot turn on and the menu is not displayed.
If this happens, press the HELP button on the remote control for 10 seconds to reset the lamp clock back to zero.
When the lamp time clock is reset to zero, the LAMP indicator goes out.
Note for US Residents
The lamp in this product contains mercury. Prease dispose according to
Local, State or Federal Laws.
4. Reattach the lamp cover.
Slip the lamp cover back until it snaps into place.
LAMP
STATUS
POWER
ON/STAND BY
USB
U
P
1
2
L
A
M
P
S
T
A
T
U
S
P
O
W
E
R
O
N
/
S
T
A
N
D
B
Y
C
E
U
S
B