Operation Manual
Table Of Contents
- INDEX
- Front cover
- Important Information
- Table of Contents
- 1. Introduction
- 2. Installation and Connections
- 3. Projecting an Image (Basic Operation)
- 4. Convenient Features
- (1) Turning Off the Image and Sound
- (2) Freezing a Picture
- (3) Enlarging and Moving a Picture
- (4) Changing Lamp Mode
- (5) Getting Integrated Help
- (6) Using a USB Mouse
- (7) Using the Optional Remote Mouse Receiver (NP01MR)
- (8) Correcting Horizontal and Vertical Keystone Distortion [CORNERSTONE]
- (9) Displaying Two Pictures at the Same Time
- (10) Preventing Unauthorized Use of the Projector
- (11) Limiting Access Level to Available Menu Items
- (12) Operation Using an HTTP Browser
- (13) Projecting Your Computer’s Screen Image from the Projector via a Network [NETWORK PROJECTOR]
- (14) Using the Projector to Operate Your Computer via a Network [REMOTE DESKTOP]
- 5. Using the Viewer
- 6. Using On-Screen Menu
- 7. Maintenance
- 8. Using Optional Lenses
- 9. Appendix
- (1) Troubleshooting
- (2) Specifications
- (3) Cabinet Dimensions
- (4) Screen Size and Projection Distance
- (5) Pin Assignments of D-Sub COMPUTER 1 Input Connector
- (6) Compatible Input Signal List
- (7) PC Control Codes and Cable Connection
- (8) Removing and Attaching the USB Wireless LAN Unit
- (9) Troubleshooting Check List
- (10) TravelCare Guide
8
1. Introduction
Terminal Panel Features
1. COMPUTER 1 IN/Component Connector (Mini
D-Sub 15 Pin) (
→
page 14, 16)
AUDIO IN (Stereo Mini Jack) (
→
page 14, 15, 17)
2. COMPUTER 2 IN/Component (R/Cr, G/Y, B/Cb, H,
V) Connectors (BNC x 5) (
→
page 14)
AUDIO IN (Stereo Mini Jack) (
→
page 14)
3. COMPUTER 3 (DVI-D) IN Connector (24 Pin)
(HDCP compatible) (
→
page 15)
AUDIO IN (Stereo Mini Jack) (
→
page 15)
4. COMPONENT IN (Y, Cb/Pb, Cr/Pr) Connectors
(RCA) (
→
page 17)
AUDIO L/MONO, R (RCA) (
→
page 17)
5. S-VIDEO IN Connector (Mini DIN 4 Pin) (
→
page
18)
6. VIDEO IN Connector (RCA) (
→
page 18)
7.
VIDEO/S-VIDEO AUDIO L/MONO, R (RCA) (
→
page
18)
8. MONITOR OUT Connector (Mini D-Sub 15 Pin)
(
→
page 16)
9. AUDIO OUT (Stereo Mini Jack) (
→
page 16)
10.
PC CONTROL Port (D-Sub 9 Pin) (
→
page 149, 150)
Use this port to connect your PC or control system
to control your projector via a serial cable. This
enables you to control the projector using serial
communication protocol. A commercially available
RS232C cross cable is required to use this port. You
can also control the projector by using PC Control
Utility 3.0 contained on the supplied User Support-
ware 5 CD-ROM. To do so you must first have PC
Control Utility 3.0 installed on your PC. If you are
writing your own program, typical PC control codes
are on page 149.
11. Remote Jack (Stereo Mini Jack) (
→
page 11)
NOTE:
• Connecting the remote cable to the REMOTE mini jack
on the terminal panel will make the wireless operation
unavailable.
• Connecting the remote cable to the REMOTE mini jack
on the terminal panel will forcibly select [NORMAL] for
[STANDBY MODE] during standby mode even though
[POWER-SAVING] has been selected from the menu.
12. USB Port (Type A) (
→
page 37)
13. LAN Port (RJ-45) (
→
page 19, 102)
14. USB Wireless LAN unit (
→
page 151)
NOTE: A dummy cover is provided on this location of the
projector without the USB Wireless LAN Unit.
The actual appearance of the terminal panel may differ slightly from that shown in the drawing, but this does not af-
fect the projector’s performance.
WIRELESS
USB(LAN)
WIRELESS
14
7 8 1011
134 12 3 2
165 9